Liebig Anchors - Wide Range Stockist
Liebig GmbH are premium manufacturers of anchoring products for a wide range of fastening requirements, including construction, safety-critical and general engineering applications. CW Fasteners keep in stock a large selection of Liebig fasteners and are situated almost next-door to Liebig's own UK warehouse and laboratory facility, ensuring rapid access to Liebig's full range and technical backup.
View the Liebig full product catalogue (PDF format).
Liebig Safety Bolt, Wedge Anchor and Chemical Resin Injection and Capsule fasteners are all kept in stock (UltraPlus and SuperPlus are both readily available to special order).
Liebig Safety Bolt
Twin cones make the expansion sleeve spread cylindrically - Getting the maximum from the concrete/brick/etc, which is often the limiting factor. Tensile and compressive loads can be supported and easy drill-through assembly makes these quick to install - there is no need to repeatedly remove and replace a fixture - drill all holes with the item in position!
A visual check of the domed washer provides for ready inspection (not applicable to the SK version, with countersunk bolt head).
Available in M6, M8, M10, M12, M16 and M20 in zinc-plated and passivated steel and stainless steel.
Types:
B = stud and nut head (shown in the image)
S = solid bolt head (not shown)
SK= countersunk bolt head (not shown)
Download full range details and fixing guidance on the Liebig Safety Bolt (PDF format).
Liebig Anchor Bolt
This single cone bolt fixing is removable and provides a secure clamping force by means of a special formed washer.
It is available in a wide range of lengths and offers drill-through assembly for rapid installation.
Available in M6, M8, M10, M12, M16 and M20 in zinc-plated and passivated steel and stainless steel.
Types:
AB = stud and nut head (shown in the image)
AS = solid bolt head (not shown)
Download full range details and fixing guidance on the Liebig Anchor Bolt (PDF format).
Liebig Chemical Anchor
Chemical anchoring products comprise:
- Resin cartridges and capsules
- Steel fixings
- Setting tools and cartridge guns
These fixings allow reduced edge and centre spacings and pre-drill assembly, allowing high-strength fixings to be made in difficult situations.
Caution: These products cannot support a load immediately - it is critical to observe the resin curing time.
Available in M8 to M30 in zinc plated and passivated steel and stainless steel.
Types:
KLS = anchor rod
KLP = mortar cartridge
Accessories: rapid setting tool
Placing an Order
Please contact us to place an order.